Section 8: Plumbing System
65
When you are done adding RV antifreeze
14. Turn the water pump OFF. Turn siphon valve OFF. Remove the clear hose from the
container of RV antifreeze. Leave the water tank shutoff valve closed to keep antifreeze
out of the fresh water tank. See
Water Heater Bypass Diagram
.
15. Pour 1 cup of RV antifreeze into the sink drain P-trap.
16. To prevent staining, wipe RV antifreeze out of the sinks, shower (or tub) and toilet us-
ing a soft, dry cloth.
NOTE: In the spring when flushing antifreeze out of the water lines, make
sure to turn the water tank shutoff valve back ON. After flushing out water
lines the water filter should be re-installed.
Air Pressure Method
This method uses compressed air to blow out any remaining water in the system after ini-
tially draining water using drain valves. Tools required would be an air compressor and a
blowout plug.
1.
Turn off the water heater gas valve typically located outside the RV. Water heater
power should be OFF.
2.
When possible, park the RV on level ground and drain the fresh water plumbing sys-
tem. See
Draining the Fresh Water System.
3.
Water heater bypass should be set to
NORMAL
. This allows air to flow through the
water heater.
4.
RV water filter cartridge should be removed for winterizing. Refer to
Water Purifica
-
tion System
section.
5.
Open the fresh water tank drain valve to avoid pressure build up in the fresh water tank.
NOTE: Filters should be replaced at the beginning of the camping season or
if they have come into contact with contaminated water or antifreeze.
6.
Run the pump until it is dry (approximately 15 to 20 seconds). Operating the pump
longer than that with no water can damage the pump.
7.
Open the fresh water tank drain valve to avoid pressure build up in the fresh water tank.
8.
Open all faucets in the RV Including the shower.
9.
Attach a blowout plug to the city water inlet on the outside of the RV. Refer to
Fresh
Water Connections
.
10. Attach the air hose to the blowout plug. Set compressor to
30 PSI
.
11. Blow air into the water lines through the blowout plug and the City Water Inlet to
evacuate all water from the lines.
12. Continue blowing out the water lines for approximately 5 to 10 minutes.
13. Pour one cup of RV antifreeze in all the drain P-traps (sinks and shower).
Never apply air pressure to the water system with any of the valves in
the closed position. Air pressure applied to a closed valve, faucet or low
point drain could potentially damage the seals and cause water leaks. If
you have questions, consult with your RV dealer. Using RV antifreeze is
the preferred method of winterization.
Recommended pressure is 30 PSI
,
Exceeding this pressure may rup-
ture water line couplings and void your warranty.
Table of Contents
Summary of Contents for SWIFT 2023
