SECTION 11
CAMPING & OPERATING
Operating the system without the filter allows
the lint and dirt that is normally stopped by the
filter to accumulate on the cooling coil of the
air conditioner. This also will lead to a loss of
air volume, possible equipment damage and
an expensive cleaning process.
A special foam gasket is placed between the
roof material and the subframe of the air
conditioner to guard against water leakage.
The air conditioner is subjected to wind
pressures along with motor vibration during
normal operation. Inspect the mounting bolts
for tightness to ensure there is no leakage or
looseness at least annually. Re-tighten bolts
when they are loose. DO NOT over tighten
these bolts as it may damage this gasket. The
air conditioner gasket is a wearable part that
eventually will need to be replaced s
maintenance. To gain access to the bolts,
remove the filtered panel cover on central air
systems or the entire air box on non-central
air conditioners.
Heat pump operation
Set the thermostat for either electric or gas
heat. On the electric setting, the Polar
Mach™ heat pump will become the primary
heat source as long as the interior
temperature of the RV has not dropped 5°
below the thermostat setpoint. If this occurs,
the thermostat will automatically activate your
gas furnace. The furnace will continue as the
heat source until the thermostat setpoint has
been satisfied. At that point, the heat pump
will again become the primary heat source.
F
URNACE
(I
F
S
O
E
QUIPPED
)
The RV furnace installed in the RV is
controlled by a thermostat. The furnace
requires both 12-volt power and propane gas
for full operation. Make sure you have
sufficient power available before operating
your furnace If you have any questions
contact your dealer or Jayco Customer
Service.
A qualified RV technician should perform all
furnace maintenance at least once a year
(more often depending on furnace usage).
Never attempt to repair the furnace yourself.
P
ATIO
A
WNING
(
IF SO EQUIPPED
)
Please refer to the awning OEM operator’s
manual. Keep your awning in good condition
The furnace should be inspected
periodically (monthly during the heating
season) for presence of soot on the vent.
Soot is formed whenever combustion is
incomplete. This is a visual warning that
the furnace is operating in an unsafe
manner. If soot is observed on the vent,
immediately shut the furnace OFF and
contact a qualified service agency.
Operating the furnace under this condition
could lead to serious property damage,
personal injury or loss of life.
To ensure your personal safety, do not
obstruct or alter the furnace in any manner.
Do not install screens over the vent for any
reason. Screens will become restricted and
cause unsafe furnace operation. For your
safety, only OEM factory authorized parts
are to be used on your furnace.
Awnings must be closed (and locked if
applicable) while the RV is in transit.
84
Summary of Contents for SENECA 2010
