![background image](http://html1.mh-extra.com/html/jayco/embark-2022/embark-2022_owners-manual_3570511053.webp)
47
Section 4: Vehicle Operation
Outside Rearview Mirrors
After adjusting the front driver’s seat, adjust the outside rearview mirrors to your driving
preference. Have someone help you adjust the mirrors in the desired direction for maximum
rear visibility before driving. During travel, vibration may loosen the fitting holding the
mirror(s), causing them to change position. As part of your regular motor home mainte-
nance, check and adjust the mirrors to the desired position.
Power Remote Mirrors (if so equipped)
You can adjust the power remote mirrors when the ignition
key is in the ON position.
1. Move the control knob to the side you want to adjust.
2. Press the control arrows in the direction you want the
mirror to move.
3. Return the control knob to the center to lock the mirror(s)
into place.
The power remote mirrors also contain heating elements to
defog or de-ice the mirrored glass if needed. To activate this
feature, use the “Mirror Heat” control located on the driver’s
side console next to the mirror control joystick.
Adjust the outside rearview mirrors before driving.
Remote Mirror Control /
Mirror Heat Control
(appearance may vary
by model)
NOTE:
Depending on models, the mirror control joystick and the Mirror
Defrost toggle switch may be separated from each other. The Mirror
Defrost switch may be renamed Mirror Heat.
Xite 360° Camera System
Your motor home may be equipped with the Xite 360°
Camera System. This system has (6) cameras mounted
around the RV. Side rear-view cameras are located on both
sides of the front cab. Four high definition (HD) cameras
are mounted at the front and rear of the RV, and one mid-
way on each side of the RV. These cameras can be operated
individually or when combined provide an overhead “birds
eye” view above the RV.
All cameras are active when the coach is in motion.
The cameras will display on the right side monitor screen
of the dash. Cameras can also be displayed on the elec-
tronic dash by selecting the Layers button on the top right of the
VDC control (located on the driver’s side armrest control). The Lay-
ers button alternates the screens on the electronic dash each time
the button is pressed. Screens alternate in this order: standard dash
screen first, navigation screen second and the camera screen third.
Pressing the button again reverts back to the dash screen.
Layers Button
Table of Contents
Maintenance Record
Summary of Contents for Embark 2022
