Jayco Eagle, Owner'S Manual

Page: 32 / 85

2 3
2. Insert the two end divider bars “C” (with gray caps) and center spacer bar “D” (7/8"
tube) into front pocket of the canopy. These bars may be left in the canopy during
travel or storage, but should be removed during winter storage to avoid corrosion.
3. Assemble the two parts of a tension rafter, Pole “A.” Insert the peg through the
“eye” of the twist pole “B” and then through the hole in the middle of the center
spacer bar “D.” Compress tension rafter and place in the center of the roof side
board, as pictured. The rubber tip from the tension rafter will rest against the roof
metal or the canopy bag.
4. If no screen room is being installed, repeat step #3 on the front and rear tension
rafter, inserting the end of the tension rafter through twist poles “B” and the end
divider bars “C.” Position tension rafter as in step #3.
5. After all the poles are installed:
a) Adjust the canopy to fit properly.
b) Adjust the height of the canopy with the twist lock poles.
c) Install the three stakes to anchor the canopy in case of strong winds.
CAUTION: Always install the stakes to avoid wind damage to the poles and the
fabric. In severe wind it is best to remove the canopy. Wind and rain damage are not
covered by warranty.
Fig. 3-8