Jayco 2014 JAY FLIGHT, Owner'S Manual

Page: 81 / 128

JAYCO TOWABLE SECTION 7 – FUEL SYSTEM
7-5
The following label should be kept permanently affixed to your RV.
Fig. 7.4 “Do not fill to more than
80%” label
Refer to your Warranty Packet for more information on the LP gas system
components.
I
NSTALLING
P
ROPANE
C
YLINDER
(
S
)
Single Cylinder Mounted On A-Frame (if so equipped)
Fig. 7.5 Single cylinder
1. Connect the 3/8" low pressure hose to the outlet of the two stage regulator.
2. Attach the regulator with the “Z” bracket on the center of the front wall with the
vent pointing down.
3. Attach the protective plastic cover to the regulator.
4. The regulator has a 90° elbow that directs the inlet toward the trailer curbside.
5. Place the cylinder on the bracket provided on the A-frame and position it so
the outlet of the cylinder valve is pointed directly outward to the curbside wall.
6. If a vinyl cylinder cover is provided, slip it over the cylinder and leave the
zipper open (if so equipped).
7. Attach the 1/4" inverted flare x 24" Type 1 pigtail hose to the regulator inlet
and the right hand swivel nut to the cylinder valve.
8. If applicable, close the cylinder cover zipper (if so equipped) up to the hose.
9. Secure the cylinder to the A-frame bracket using the bolts, nuts and washers
provided.
Double Cylinder Mounted On A-Frame (if so equipped)
When a second cylinder is installed, a tee check valve is used to replace the 90°
elbow at the top of the regulator and another 1/4" inverted flare x 24" Type 1 pigtail
is added. The regulator stays in the original position.
WARNING
Ensure that all fasteners are secured before traveling.