Jayco 2011 pinnacle, Owner'S Manual

Page: 73 / 97

SECTION 10
CAMPING & OPERATING
K
EYS
Several keys are provided when you
purchase your RV. Most keys have an
individual key number stamped on the plate.
Record these key numbers and keep the
information in safe place. You can order a key
blank from your RV dealer to have duplicate
keys made. If you lose the keys, contact your
RV dealer or a locksmith for assistance.
Make sure the keys are not inside the RV
before you close and lock the entrance
door.
E
NTRANCE
D
OOR
W
ITH
S
TORM
D
OOR
The entrance door is located on the curbside
of the RV. Always hold onto the entrance door
when opening or closing it as damage caused
because you failed to do so is not
warrantable.
BE SAFE, LOOK BEFORE ENTERING OR
EXITING YOUR RV!
H
IDE
-A-B
ED
(
IF SO EQUIPPED
)
The hide-a-bed sofa functions much the same
as a regular residential hide-a-bed sofa. To
make the hide-a-bed sofa into a bed, remove
the seat cushions and pull the sofa back
towards you firmly and gently. Activate (or
deflate) the air mattress using the supplied
furniture manufacturer’s instructions. To
convert the hide-a-bed back into the upright
sofa position, reverse the process .
F
REE
-S
TANDING
T
ABLE
&
CHAIRS
(I
F
S
O
E
QUIPPED
)
The free-standing dinette table can be
positioned to seat up to four people. To
prevent damage, the standard free-standing
dinette chairs should be fastened securely at
the dinette table when you are traveling
B
OOTH
D
INETTE
(I
F
S
O
E
QUIPPED
)
The dinette is designed to seat up to four
adults. You can access the dinette bench
storage by removing all the cushions and
lifting the bottom seat supports.
If the dinette bottom seat support is screwed
shut, it is to protect factory-installed
equipment (do not use that area for storage).
To convert the booth dinette into a sleeping
area:
□ Remove all the cushions from the booth
dinette.
□ Lift the tabletop, remove the detachable
table legs and place the tabletop on the
ledges provided between the booth
dinette benches.
□ Lay the seat back cushions against the
back of the booth dinette bench.
□ Lay the dinette seat bottom cushions in
between the seat back cushions. The area
where the cushions meet should be
slightly raised.
□ Push the raised cushion ends down
gently. The cushions are designed to fit
snugly.
Reverse this process when converting back to
the booth dinette.
R
ECLINER
C
HAIR
(I
F
S
O
E
QUIPPED
)
Like a residential recliner, the recliner has
side controls allowing you to recline the chair.
To revert the recliner chair back to the upright
position, depress the side control and gently
apply pressure to the recliner leg rest. Refer
to the furniture manufacturer’s care
instructions for this product.
TV P
OWER
S
UPPLY
For good station reception, the
TV power supply must be turned
ON to view local television
stations. Turning the TV power
supply ON sends 12-volt DC
through the cable to the TV roof
antenna. The voltage energizes
Make sure the entrance door is completely
closed and locked when traveling. Locking
the door helps prevent it from opening
unintentionally.
Fig. 10.2 TV
Power Supply
69