Jayco 2004 Conventional Travel, Owner'S Manual

Page: 50 / 112

CEILING FAN
The ceiling fan in the unit operates as one would in a home. An owner’s manual is provided
with detailed instructions for its use from the ceiling fan manufacturer. If you have further
questions, consult with your independent, authorized dealer and/or the ceiling fan
manufacturer.
SECURITY LIGHTS
The security lights can be turned on or off from the entry or bedroom switch.
FLOOR SAFE
Your trailer may have a safe installed in the floor of the closet or under the bed . The safe is
intended to be used by the retail customer to safe guard valuable items. Jayco can not be
held liable for loss of personal property that is placed within the safe. To secure items in the
safe, a padlock will need to be supplied by the end user and attached through the provided
hasps on the safe . If you have questions, consult with your independent, authorized dealer.
MONITOR PANEL
The monitor panel will provide useful information on the capacities of the water tanks and
the battery condition. Your trailer has a wall mounted panel. Follow instructions below
regarding operation. If you have further questions on the operation, refer to information
supplied with your trailer by the monitor panel manufacturer, consult with your
independent, authorized dealer and/or the monitor panel manufacturer.
The panel operates on 12-volt DC power supplied by the converter or battery. Sensors are
installed into the tanks and a resistor assembly relaying a message through wires to the
display board on the panel. No power is drawn from the battery unless a switch is pushed or
turned on.
OPERATION
Spring loaded push button switches are located on the monitor panel. Press only one button
at a time, as one set of lights serve all functions. As you push any button, one or more lights
will come on, indicating the tank contents level.
When pushing the battery button, the highest light coming on indicates battery condition.
C=charging at 12.7 volts; G=good at 11.9 volts; F=fair at 11.2 volts; and L=low at 6.0 volts.
When the water pump switch is in the “ON” position, the pump runs until 45 pounds of
pressure has been achieved. The red light will stay on. Turn the switch off when the pump is
not in use.
The heater switch is for the direct spark ignition (D.S.I.) water heater operation.
Fuses for the monitor panel operation are in the 12-volt distribution center fuse block.
40
At Camp...