Australia
New Zealand
www.jaycar.com.au
www.jaycar.co.nz
1800 022 888
0800 452 922
Page
1
of
5
TL4412 Quick setup
guide
Tri Colour 3D Printer
About this printer
The Dobot MOOZ-3 tri-colour printer is a unique product offering filament mixing
capabilities on a small heated bed. The printer comes with 3 colours for the CYM colour
space, which can be blended together within the nozzle to achieve a large range of
colours; The mixing modes also come in 2 styles:
Gradient mode, which will mix between 2 colours over a desired length.
Colour change mode, which will mix and form up to 4 different colours, changing
after each length.
We will go over the colour controls later in this document. Firstly, we will look at making
sure we get the connections and the zero point levelling correct.
Quick start printing guide
We always recommend reading the manual in entirety before printing, but if you already
have and want to get started with printing, have a look at this simple checklist:
1. Set up the printer by assembling and connecting the 3 extruder motor filament
mounts as shown, the X tower must connect into the port labelled
“X” on the base
board.
2. Connect up the control and base station according to the diagrams below, with the
A-A and B-B leads. Notice that they do cross over.
