MAINTENANCE
Sunrise recommends that all fasteners be checked for wear, such as
loose bolts or broken components every 6 months. Loose fasteners
should be retightened according to the installation instructions. All
fasteners should be tightened to torque specifications as stated in
the hardware installation section. Contact your authorized Sunrise
Medical supplier immediately to replace any broken components.
Do not continue to use the system after identifying loose or broken
components.
NOTE–
Wrench has been included with the back for your convenience.
EASY CLEANING
NOTE–
When disassembling the back for cleaning, note the position of
the Velcro® Lumbar Positioning Components for correct
reassembly.
To clean back cover
Remove cover by detaching Velcro. Detach cover from back shell.
Locate zipper on bottom of the cover and unzip. Remove foam
with inner cover and turn cover inside out. Zip cover closed to
avoid snagging. Machine wash in warm water (50°C). Drip or tum-
ble dry on low heat.
NOTE:
Do not dry clean covers or use industrial washers and dryers to
clean cover. Do not steam autoclave. Do not bleach.
Reinsert the foam with inner cover into the cover. Please note, the
base has two layers of foam. When reinserting the foam, ensure
that the thinner, firmer, light grey foam is facing the shell and the
softer foam is facing the user. Once the foam is secured inside the
cover, zip cover closed.
To clean back shell and Inner Cover
Shell and inner cover may be wiped clean with soap and water.
No other maintenance should be required.
To clean positioning components
Positioning components can be wiped clean with soap and water.
Do not immerse positioning components underwater.
If you have any additional questions regarding cleaning procedures,
please contact your authorized Sunrise Medical dealer.
MAINTENANCE AND CLEANING
E N G L I S H
Laundry Care Symbols
Machine wash in warm water
(50° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
4
120688 Rev. B
