Page 29 / 41
Ref doc :
330740F/EN
revision 01
29.09.2015
8.3 Configuring the transmitter.
8.3.1 Procedure for programming frequency
1-
Switch on the receiver.
2-
Insert the electronic key in the transmitter.
3-
- Press and hold buttons B1 and B2,
- unlock the emergency stop palmswitch on the transmitter (fig.1),
- Wait until the orange indicator goes off before releasing buttons B1 and B2.
The channel currently selected is indicated by two flashing indicator lights on the transmitter representing the
tens (orange) and the units (green).
4-
Select the new channel using channels B1 and B2 (Figs.2&3).
By pressing button B1, the tens are incremented ; by pressing button B2, the units are incremented.
During these operations, the newly selected channel is indicated by the 2 indicator lights on the transmitter
which flash accordingly.
5-
Once the desired channel is selected (choice of No. 01 to 64), press the
“ON” button to validate your selection
(Fig. 4).
Briefly press « ON » :
The transmitter sends the number of the selected channel to the receiver and saves its
new working channel (Fig.5).
By pressing and holding « ON » (3 seconds) :
The transmitter sends the number of the selected channel to
the receiver (on each of the radio link channels) and saves its new working channel. Wait until the transmitter
indicator lights stop flashing (around 30 s.) (Fig.5)
(this procedure, which is preferable but longer, should be
followed when you do not know the initial working channel of the receiver)
.
6
- Exit the « frequency » programming mode by pressing the emergency stop palmswitch (Fig. 6).
