8
Receiver could be connected with up to 4 indicators at the same time.
How to setup receiver:
1.
Switch on all indicators shall be programmed.
2.
Before switch on receiver press and hold on few seconds both buttons
V (3) and ON/OFF (4), until red LED is on.
3.
Move roller (A) of bite indicator which shall be connected to red LED,
the receiver confirmed connection and then yellow LED is on.
4.
Follow the same way to connect next indicator with yellow LED.
When connection is done green LED is on.
5.
Follow the same way to connect third indicator with green LED. When
connection is done blue LED is on. When fourth indicator is connected
receiver will switch off automaticaly..
6.
When setup is done please check connections with all receivers.
To finish setup earlier than connect four indicators or chose other color on
receiver press V (3) few times. Press V (3) when blue LED is on finish
setup and switch receiver off.
Each time you start new setup, all old data will be erased.
1.
Don’t put into water.
2.
Any repairs should be made by Authorized Service. Do not attempt
to disassemble the bite alarm yourself
3.
Clean the bite alarm with a slightly damp cloth. Do not use soap or
solvent.
4.
If the bait indicator is not in use for some time, remove batteries.
WARNING
RECEIVER SETUP