3. LOADING THE PRINT PAPER
Check and see if power is turned on.
Turn the nut(with a driver on the groove in the middle) on the lower printer cover
clockwise to 90 degrees and open the cover.
Load the print paper as shown in the picture.
Insert the paper edge deep under the black roll, then it comes out above the CUTTER.
Balance the paper in the right place.
Cut the paper by pressing the FEED button.
Close the cover and turn the nut counterclockwise back.
4. CONNECTING PORTS(RS-232C)
To transmit the data with connecting a
computer or other external options to the unit.
Connect the RS-232C cable both to port of
the unit and to the computer jack or other
external options(See the picture)
Note
Being thermal type, printing is photocopied on one side of the paper(slippery side),
without using printing ink.
Please check remainder of the paper always and then replace it.
Please use exclusive paper (58mm).
Keep paper rolls in a dark and ventilated place.
Avoid any dust etc. on the paper.
Do not pull the paper during printing. It could cause jam.
When printing paper is not loaded in correct place, it may cause the malfunction of
the printer or paper will be shoved out.
