Operator’s Manual
ATTACHING LOADER
Attaching and detaching of the loader should be performed on even and solid ground.
1.
Drive tractor as centrally as possible into loader. Pins (1) will slide onto brackets (2) on tractor, all
the way into their final location “X”. Stop engine and engage hand brake.
If loader height does not match the height of the brackets on tractor, proceed as follows:
(A)
Drive tractor as close to the loader as possible. Stop engine and connect four loader hoses to
hydraulic couplers (follow color coding on couplers).
(B)
Start engine and tilt the bucket slowly as needed to adjust the height of the loader to match the
height of loader brackets on tractor.
2.
Move levers (3) (one on each side of the
Loader) all the way down until latch (4)
Engages.
Note:
Do not force levers (3) down.
If levers cannot be pushed down
by hand, tractor needs to be
moved closer to the loader.
3.
Connect four loader quick couplers if you have not done so earlier (follow color coding on the
couplers)
4.
Start engine and lift loader a few inches
from the ground using the joystick control.
Stop the engine.
Fold loader stands up.
5.
Start the engine and continue lifting the loader slowly all the way up. During lift, make sure the
four hoses connecting the loader with the loader valve are shaped appropriately and will not be
stretched or damaged by some loader part.
Note:
Gearbox oil level in tractor should be at the top mark.
Check oil level with the engine stopped.
T50SS/T50HLSS
4
