Javad Prego, Operator'S Manual

Page: 48 / 152

2-12 Prego Operator’s Manual www.javad.com
C O N F I G U R A T I O N
Prego Configuration
2
5. Select the Power output modes Ports drop-down list to set power output
on serial ports (Figure 2-15).
Figure 2-15. Select Power Output Modes – Ports
• On – the power board will deliver voltage on pin 1 of all serial port
connectors when the receiver is turned on. If the receiver is turned off,
there will not be any power on the ports.
• Off – the power will be absent even if the receiver is turned on.
• Always – the power board will deliver voltage on pin 1 of all serial port
connectors even if the receiver is turned off.
6. Select the Power output modes Slots drop-down list to set power output
on internal slots (Figure 2-16).
Figure 2-16. Select Power Output Modes – Slots
• On – all slots are powered if the receiver is turned on.
• Off – internal slots will not be powered even if the receiver is turned on.