Javad Maxor, User Manual

Page: 63 / 142

www.javad.com Maxor User’s Manual 2-29
C O N F I G U R A T I O N
Radio Configuration
%%set,dev/ser/c/rate,38400
%%set,cur/term/rate,115200
Figure 2-36. Manual Mode Command Responses
21.
Click Disconnect (Figure 2-36). Continue with other configuration or
operation functions as needed.
Configuring a GSM Radio Modem
Notice: To comply with RF exposure requirements, maintain at
least 20cm between the user and the GSM radio modem.
To access your GSM radio modem, you will need to use FieldView or PCView.
FieldView users can configure the GSM radio modem through the program's
GUI whereas PCView users will have to execute all necessary GRIL commands
in manual mode.
How to Configure a GSM Radio Modem with PCView
1.
Connect your receiver and computer using an RS232 cable and appropriate
serial ports.
Also, if your Maxor receiver has a USB port, you can use a USB cable and a
computer with the JNS USB driver installed (this driver is available to
download from http://www.javad.com/).