Javad Maxor, User Manual

Page: 55 / 142

www.javad.com Maxor User’s Manual 2-21
C O N F I G U R A T I O N
Radio Configuration
•
After taking the receiver out of Sleep Mode.
Radio Configuration
The internal radio in your Maxor and the Base radio can be configured
differently depending on your needs and working conditions. The software
program required to configure the radio modem differs depending on your
receiver configuration, and allows you to:
• access the internal modem
• configure the modem
• check or change the modem configuration
The following sections provide basic radio configuration information for UHF
and GSM radio modems.
Notice: Your receiver may be configured without a radio modem.
If this is the case, please skip to “Bluetooth Module
Configuration” on page 2-31.
Configuring a UHF Radio Modem
To access your PDL UHF radio modem, you create a daisy chain between the
Maxor serial port (A or D) and the radio modem (Port C) using PCView. You
then activate the PDL configuration program on your PC and proceed with the
radio configuration.
1.
Connect your receiver and computer. See “Connecting the Maxor and a
Computer” for this procedure.
2.
On the Connection parameters dialog box, select a 38400 baud rate and turn
off the RTS/CTS parameter (if needed).
3.
Once connected, click on File->Manual Mode to open the Manual Mode
dialog box (Figure 2-22).
Figure 2-22. File->Manual Mode