Javad Maxor, Operator'S Manual, Page: 87 / 164

www.javad.com Maxor Operator’s Manual 3-9
S E T U P A N D M E A S U R I N G
Measuring with the Maxor
3. Click the Advanced tab and then the Multipath tab, set the following
parameters, then click Apply (Figure 3-6 on page 3-9):
• Code Multipath Reduction – enable
• Carrier Multipath Reduction – enable
Figure 3-6. Advanced->Multipath
4. Click the Loop Management tab and set the following parameters,
then click Apply (Figure 3-7 on page 3-10):
• Enable Common Tracking – enable