www.javad.com
Maxor Operator’s Manual
2-43
C O N F I G U R A T I O N
Bluetooth® Module Configuration
•
Encryption
– enable to have the Bluetooth® module encrypt wirelessly
sent data. To read encrypted data, the user must have the same PIN used in
the device that sent the data.
•
Authentication
– enable to require a PIN before two Bluetooth® enabled
devices (such as, the receiver and a computer) can establish a
communication link. The two devices must use the same PIN.
Notice
If you do not need security settings, leave these
parameters disabled.
Figure 2-34. BTCONF Security Parameters
9.
Click the
Serial Interface
tab (Figure 2-35). Enable
Echo
to display
Bluetooth® module replies and corresponding commands on the computer
terminal. If needed, click
Apply
.
Figure 2-35. BTCONF Serial Interface Tab
10.
Click
Disconnect
then
Exit
to quit BTCONF.
Summary of Contents for Maxor
