Javad LGG100, Operator'S Manual

Page: 39 / 62

www.javad.com LGG100 Operator’s Manual 3-5
O P E R A T I O N
Checking Firmware Version
Using PCView to Clear NVRAM
1. Connect your receiver and computer. See “Connecting the LGG100 and
a Computer” on page 2-2 for this procedure.
2. Start PCView.
3. Click Tools->Clear NVRAM (Figure 3-4).
4. Click OK at the clear NVRAM confirmation dialog box.
Figure 3-4. Tools->Clear NVRAM
The receiver will automatically disconnect once the NVRAM is cleared.
Checking Firmware Version
Use PCView to check the firmware version of your receiver.
Notice: The LGG100 receiver should be loaded with firmware
version 2.3 or newer.
1.
Connect your receiver and computer. See “Connecting the LGG100 and a
Computer” on page 2-2 for this procedure.
2.
Start PCView.
3.
Click on Help->About (Figure 3-5).
Figure 3-5. Help->About