Javad LGG100-GG, Operator'S Manual, Page: 67 / 92

www.javad.com LGG100-GG Operator’s Manual 67
O P E R A T I O N
Clearing the NVRAM
Using MinPad to Clear NVRAM
1. Press the power key to turn off the receiver.
2. Press and hold the FN key.
3. Press and hold the power key for about one second. Release the power
key while continuing to hold the FN key.
4. Wait until the STAT and REC LEDs are green
5. Wait until the STAT and REC LEDs blink orange.
Release the FN key while the STAT and REC LEDs blink orange.
Using PCView to Clear NVRAM
1. Connect your receiver and computer. See “Connecting the LGG100-
GG and a Computer” on page 27 for this procedure.
2. Start PCView.
3. Click Tools->Clear NVRAM (Figure 4-12).
4. Click OK at the clear NVRAM confirmation dialog box.
Figure 4-12. Tools->Clear NVRAM
The receiver will automatically disconnect once the NVRAM is cleared.