19
Torch & Wire Feed Set Up for Aluminum Wire
(1) Lay the torch out straight on the ground and remove the front end parts
(2) Remove the liner retaining nut.
(3) Carefully pull the liner out of the torch cable assembly
(4) Select a PA or Teflon liner and carefully unravel it without kinking it.
(5) Carefully and slowly feed the liner in short forward movements down the cable assembly all the way
through and out the torch neck end. Avoid kinking the liner, kinking the liner will ruin it and require re
placement. Leave the liner extending out the end of the torch neck end by 1/8”.
(6) Fit the contact tip to the torch end.
(7) Fit the liner retaining nut together with the liner o-ring.
(8) Push the liner firmly into the torch lead and tighten the liner retaining nut.
(9) Cut the liner flush with the end of liner retaining nut using a sharp box cutter knife.
(2) Remove the liner retaining nut
(3) Carefully pull out and completely
remove the liner
(4) Carefully unravel the new liner
(8) Push the liner firmly into the torch lead
and tighten the liner retaining nut
(5) Carefully feed in the new liner in short
forward movements down the torch lead all
the way to exit the torch neck. Be careful not
to kink the liner
(9) Cut the liner flush with the end of liner
retaining nut using a sharp box cutter knife.
(6) Fit the correct tip
(1) Remove mig torch front end parts
(7) Fit the liner collet, liner O-ring and liner
retaining nut.