HR800C
Copyright
©
2005 JAS Teletech Co., Ltd.
www.jasteletech.com
10
4 Appendix
4.1 Trouble Shooting
If Home Repeater does not operate properly after installation and the signal level of your
mobile is same as before, make sure that the installation procedures as described in this manual
were followed correctly. You may check out the following step for the inspection
4.1.1 Inspection Procedure
No.
Inspection Step
Remark
1
Power LED
The green light should be on if the power is on.
2
Down link LED
The green light should be on, if it is normal. If
green and red light is blinked, please check next
step.
3
Up link LED
The green light should be on, if it is normal. If
green and red light is blinked, please check next
step.
4
Connection of the port
(To mobile & To BTS)
To Mobile: The dipole antenna (Service
antenna) should be connected
tightly.
To BTS: The donor antenna (Patch antenna)
should be connected tightly.
5
Cable connection to donor
antenna
The cable should not be broken or any other
damaged.
♦
If the signal level of your mobile is still same as before, you might change the donor
antenna location to get better signal from base station.
♦
If there is any obstacle between Home Repeater and mobile, the signal of your mobile
would be fluctuated. You may check the location of Home Repeater and re-install it.
♦
If the red light in LEDs of Home Repeater is still blinked and the signal level of mobile
is same as before although you inspect them through the above procedure, you may
contact sales agent or manufacturer.