notice to operators, maintenance
and cleanup personnel
Model SEC 180
page 3 of 16
JARVIS
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457–4926
UNITED STATES OF AMERICA
TEL. 860–347–7271 FAX. 860–347–6978
6204012::.
1. Disconnect the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before making any blade changes.
2. Disconnect the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repair or maintenance.
3. Disconnect the power supply - or have the power supply disconnected - in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
4. Disconnect the power supply when the tool is not being used.
5. Never put fingers, hands or other parts of the body on the cutting edge or within the cutting path of the
tool.
6. Never allow people to walk in front of the tool during its use.
7. Never allow people to hold / restrain the carcass while operating the tool.
8. Test the tool prior to use or daily. For single trigger tools: Depress the trigger and the tool should start.
Release the trigger and the tool should stop. For dual trigger tools: Depress each trigger individually
and the tool should not start. Depress both triggers simultaneously and the tool should start. Release
either trigger and the tool should stop. If the tool malfunctions, remove it from service and report or
repair it immediately.
9. Test the brake prior to use or daily. After releasing either or both triggers, the tool should stop within
2.5 seconds. If the tool malfunctions, remove it from service and report or repair it immediately.
10. Never depress the trigger unless you want to use or test the tool.
11. Never make modifications or alterations to the tool. Report or replace any missing or illegible labels.
12. Always use both hands when starting and operating the tool to avoid the risk of possible “kick back”
or “recoil.” Continue holding the tool with both hands until the saw blade comes to a complete stop.
NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
Keep hands clear.
