Revision 1: May 2018 Jarvis Lighting
’
s Terms and Conditions are available at www.jarvislighting.com
sides (Fig. 1). These will be used to fasten the wall pack to the wall.
3.
Determine if the fixture is to be installed in the “Forward Throw” or “Dark Sky” orientation (Fig. 2). Install
wall pack’s mounting plate to surface of wall using appropriate fasteners (Fig. 3). Use silicone sealant
over fasteners to ensure water cannot enter through mounting holes.
4.
Bring electrical to wall pack mounting plate. Seal all threads with silicone to ensure water
cannot enter through conduit entrances.
5.
Slide front section of luminaire down onto the wall pack mounting plate’s top hinges. Make all electrical
connections as labeled on luminaire power supply (Fig. 4). Note: if ground connection is made through
the electrical conduit, both ground tabs on luminaire must be connected with each other. This ensures
that both sections of the wall pack are grounded. Use 90°C rated supply conductors.
6.
Secure plastic connectors together to ensure that the battery is connected to the emergency driver as
intended. A single LED should illuminate until AC power is sent to the luminaire.
7.
Close up wall pack and reinstall screws to secure both sections of wall pack together. Check that seals
are all properly positioned to ensure no water enters luminaire.
Dark Sky
Orientation
Forward Throw
Orientation
Fig. 3
Fig. 2
Dark Sky
Orientation
Forward Throw
Orientation
Black = Live
White = Neutral
Green = Ground
Dark Sky
Orientation
Forward Throw
Orientation
Fig. 4