Revision 1: May 2018 Jarvis Lighting
’
s Terms and Conditions are available at www.jarvislighting.com
1950 Estes Ave
Elk Grove Village, IL 60007
Phone (800) 363-1075
Fax (312) 284-5576
www.jarvislighting.com
AL-EMER
S
ERIES
–
S
AFETY
I
NSTRUCTIONS
IMPORTANT SAFEGUARDS
– READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
Do not let power supply cords touch hot surfaces.
2.
Do not mount near gas or electric heaters.
3.
This emergency luminaire contains batteries. Use caution when servicing batteries. Battery acid can
cause burns to skin and eyes. If acid is spilled on skin or in eyes, flush with fresh water and contact a
physician immediately.
4.
Equipment should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
5.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition. Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
AL-EMER
S
ERIES
–
I
NSTALLATION
I
NSTRUCTIONS
Materials Required by Contractor:
- 90°C rated supply conductors
- Fasteners to mount luminaire to wall
- Silicone Sealant Caulk
-
5/32 hex key
Before Starting Work:
- Ensure that all electrical connections are not live! Take all steps necessary to make sure that
electrical connections will not become live accidentally during installation.
- Ensure input voltage is correct per ETL label on luminaire.
- Servicing to be performed by qualified service personnel ONLY.
Installation Steps:
1.
Remove two screws on side of wall pack, allowing the two sections
of the wall pack to hinge apart. Separate two parts of wall pack.
2.
Drill pilot holes in wall pack mounting plate; for ability to reverse
orientation after initial installation, this is typically done halfway
between the “long” and “short” end, equidistant from the other two
Dark Sky
Orientation
Forward Throw
Orientation
Fig. 1
