Connection with the Last Paired Device
When powered on, the headset will automatically connect
with the last successfully paired device. If the connection
is successful, it enters standby mode. If the devices fail to
connect within 5 minutes after the pairing has been
initiated, the headset will turn off automatically.
Multi-Connection Mode
1. Pair your first Bluetooth device to the Jarv Mach 1 by
pressing down the multi-function button for approximately
7-8 seconds until the blue/ red light flash alternately and
select “Jarv Mach 1“ from your list of Bluetooth devices
(Refer to “PAIRING WITH YOUR DEVICE” for more details ).
Once the Jarv Mach 1 headset is Connected,
Power OFF
the headset.
2. Pair the second Bluetooth device by pressing down on
the multi-function button for approximately 7-8 seconds to
enter Pairing mode again. Select “Jarv Mach 1” from the list
of Bluetooth devices to connect.
3. Go back to the first Bluetooth device, go to your list of
Bluetooth devices, select “Jarv Mach 1” to connect it.
4. Both Bluetooth devices should now be connected to your
“Jarv Mach 1”
Troubleshooting
If you are unable to connect your headset and mobile phone,
please try the following:
•
Ensure that your headset is fully charged and powered on.
•
Ensure that the headset is paired with your mobile phone.
•
Ensure that your mobile phone's Bluetooth feature is
activated. Please refer to your mobile phone user’s guide for
specific instructions.
•
Ensure that the headset is within a 10 meter (30 ft.) range
of your mobile phone and that there are no obstructions, such
as walls or other electronic devices, between the two.
•
If the above steps do not solve your problem, please
remove your mobile phone battery for a short time and
recharge the headset. Repeat the troubleshooting sequence.
*Please make sure that your headset is fully charged before
using the Multi-Connection mode
Resetting your Bluetooth device
Turn the headset on, simultaneously press and hold down
the " -” and “+” button for 5 seconds or until you hear an
audible beep confirming the reset. This will clear all
settings/memory.
If you are experiencing Bluetooth connection issues - KEEP THE
MUSIC DEVICE AT OR ABOVE WAIST LEVEL ON THE SAME SIDE AS THE
HEADPHONE ANTENNA WHICH IS LOCATED IN THE CONTROL. Your body
is 80% water. Water blocks low power radio signal like Bluetooth. In
the absence of nearby ceilings for signal bounce, your body can block
the signal between the music device and the headphones. When
outdoors or at the gym the use of armbands or wrist-worn music
players are recommended. Having your music player in your pants
pocket below waist level may produce varied results as your body can
get between the music device & headphones.
