17
NOTE:
If using keyboard for RS232 mode, the Shift, CTRL and
ALT are not implemented.
If you want to use RS232 mode,the key value is from Hex 00
to FF.
If you want to use IBM keyboard wedge mode, the key
value is coorespondent to the key table refer to Appendix I.
If using POS demo on OS2, you will have to press ALT
and HOME. This will display the key layout. Also you
will have to press ALT and P which assigns the
keyboard to the window.
When you like to escape from this window,press ALT and
HOME.
(2) Setup Misc timings.
Set Delay before run out.
? * 10mS.
Set Rate for run out.
? * 10mS.
Set Beep time.
? * 10mS.
Set Click time.
? * 10mS.
Set Keyboard Data stream ID BYTE!!
Set Aux RS232 Data stream ID BYTE!!
Set Baud rate. 300 - 19200 BPS.
(a) Set Delay before run out. ? * 10mS.
Run out delay is the time taken from the key
depression until the key starts to run out.
Enter DELAY BEFORE KEY RUN, Entry is a decimal
multiple of 10mS:-
6
A good value to enter here is 6 .
(b) Set Rate for run out. ? * 10 mS.
Rate for run out is the rate between two repeat
keys.
Enter KEY RUN REPEAT RATE, Entry is a decimal
multiple of 10mS:-
10
A good value to enter here is 10.
