About
About
1,000 km
1,000 km
About
1,000 km
Berlin
Berlin
Berlin
London
London
London
About
About
1,000 km
1,000 km
About
1,000 km
Osaka
Osaka
Nagoya
Nagoya
Sendai
Sendai
Osaka
Nagoya
Sendai
N
About
1,000 km
Tokyo
Tokyo
Tokyo
About 1,000 km
Denver
Chicago
Chicago
Ne
New
w Yor
ork
Los Angeles
Los Angeles
Los Angeles
Chicago
New York
CAL TP17
INSTRUCTION MANUAL
SPECIFICATIONS
Reception
Reception frequency
1)GERMANY............77.5KHz(DCF77)
2)U.K........................60KHz(MSF)
3)U.S.A.................... 60KHz(WWVB)
4)JAPAN.................. 60KHz(JJY)
Automatic reception (maximum two times a day)
Manual reception
Basic functions
Analog part.................Hour/Minute/Second
Digital part
Calendar
Alarm
5 languages display
Battery life .................. About 2 years
Battery........................CR2016x1
NAMES OF PARTS
CAUTION !
Before using, be sure to set the “TIME ZONE”.
For setting of the “TIME ZONE”, see “5.TIME ZONE SETTING”
at right.
TO-Y0082
RADIO WAVE CONTROLLED WATCH
6
About this radio wave controlled watch
This watch receives calibration signal and automatically updates the
time and date.
6
Transmitter
GERMANY
Signal code : DCF77
Location :
Mainflingen Germany (located 25 Km southeast of
Frankfurt)
U.K
Signal code : MSF
Location :
Rugby city (located near from London)
U.S.A
Signal code : WWVB
Location :
FortCollins in Colorado (located 100Km north of
Denver)
JAPAN
Signal code : JJY
Location :
Mt.Haganeyama (located 45Km southwest of
Fukuoka)
The signal usually operates 24 hours of a day, but it may be
temporarily interrupted for maintenance and lightning
cuntermeasure.
6
Radio wave reception zone
This watch can receive radio waves within a radius of about 1,000km
from the standard radio wave station. However, the coverage can
vary depending on time, season, weather conditions, local
environmental conditions, etc.
5-68-10, Nakano, Nakano-ku, Tokyo, 164-0001, JAPAN
Phone: 81-3-5345-7860, Fax: 81-3-5345-7861
Which way to point the watch during reception
Flatten the wristband so it doesn't curl
under the antenna.
* The indicated reception area is for your reference only. Sometimes you cannot receive radio waves
even within the zone shown in the figure.
6
How to successfully receive radio waves
• It may be difficult to receive radio waves when metal shielding blocks the watch. When
inside a ferroconcrete building etc., try to place the watch near a window that is as close
as possible to facing the radio wave station.
• Try not to move the watch during radio wave reception.
• Good reception can be achieved if you aim the reception antenna (on the upper side of
the watch) toward the radio wave station.
• You can check signal strength by looking at the reception mark that is displayed during
radio wave reception. If you find a place and a direction to aim the watch in advance that
has stable reception, that will help to get a good connection.
* The watch may fail to receive radio waves or may receive them inaccurately near (within
10km from) the standard radio wave station. In this case, change the direction of the
antenna by 45 - 90 degrees or receive radio waves again at a place far (10km or farther)
from the standard wave station.
* Sometimes when the watch indicates strong radio wave reception, it still may not be able
to receive a signal due to surrounding environmental interference such as electrical
noise.
* The maximum time required to receive a complete signal can be up to 13 minutes. It may
change depending on distance from the standard radio wave station, time, season,
weather, etc.
6
Places where it may be difficult to receive radio waves
• Places with extremely high or low temperatures.
• Inside ferroconcrete buildings, underground, inside high-rise buildings, in valleys between
mountains, etc.
• Inside vehicles, trains, and airplanes.
• Places that tend to have electrical noise such as near high voltage cables, electric train
cables, and near airports.
• Near home appliances such as televisions, refrigerators, computers, fax machines,
inverter fluorescent lights, OA machines, and operating cellular phones.
* The watch operates using its built-in quartz accuracy under conditions of poor reception.
When it returns to a reception area and receives radio waves, the watch displays the
correct time. The watch operates using its built-in quartz accuracy between signal
reception cycles.
AUTOMATIC RECEPTION
If you receive radio waves properly, the time and date are adjusted automatically.
• The watch automatically receives radio waves a maximum of two times a day.
• If one of the two reception attempts is successful, automatic reception won't be
attempted again until the next day.
During the daylight saving time period, if the watch receives the radio waves normally, it
automatically displays the SUM. If it receives the radio waves normally after the DST
period, it automatically displays the ordinary time.
• Since the DST is automatically corrected, you do not need to correct it, as long as the
watch receives radio waves. In a district where the DST is not applied, however, you are
required to correct the DST manually.
AUTOMATIC RECEPTION
2:05AM, 3:05AM
●
SELECTION OF DISPLAY
1. MANUAL RECEPTION
Signal reception takes 2~13 minutes.
3. MANUAL ADJUSTMENT TIME
AND CALENDAR
2. CONFIRMING RECEPTION RESULTS
TIME
TIME
4. ALARM
• ALARM ON/OFF
• ALARM SETTING
5. TIME ZONE SETTING
Select a country and a time zone where you will use this watch.
If the country is selected, the radio wave is decided.
The relationship between the countries and radio waves is
shown in Table below.
6.LANGUAGES SETTING
8. BATTERY REPLACEMENT
When the display dims, replace the battery as soon as possible.After
battery replacement, please make sure to short two pattern on module,
and reset hands initial position refering to "7.CHECK AND RESET
HANDS INITIAL POSITION".
7 . CHECK AND RESET HANDS INITIAL POSITION
It may happen that hands slip and change to incorrect position, because
of hard shock, static electricity and after battery replacement and so
on.In this case, we cannot adjust to correct time, even we receive the
wave, because hands initial position is not correct.
Please check and reset hands initial position as following operation.
Correct hands initial position is "12H00M00S".
* Please don't do following operation, when you don't have any problem.
1) In the case of correct position("12H00M00S")
No need to reset hands initial position.
2) In the case of incorrect position( not "12H00M")
Need to reset and adjust hands initial position.
TIME ZONE
–12
–11
–10
–9
–8
–7
–6
–5
–4
–3
–2
–1
+0
+1
+2
+3
+4
+5
+6
+7
+8
+9
+10
+11
+12
WWVB(60KHz)
MSF(60KHz) DCF77(77.5KHz)
MSF(60KHz) DCF77(77.5KHz)
JJY(60KHz)
Honolulu
Anchorage
Los Angeles
Denver
Chicago
New York
Santiago
Rio de Janeiro
London
Paris
Cairo
Jeddah
Dubai
Karachi
Dhaka
Bangkok
Hong Kong
Tokyo
Sydney
Noumea
Welington
CITY
.
RECEPTION WAVE
Time zone list
MODE=
훽
=ADJUST
DISPLAY=
=RECEIVE
훽
Alarm mark
Summer time mark
Antenna
Radio
wave
station
Weak radio waves
Strong radio waves
Day
Date
Alarm
“ALARM OFF” and “ALARM ON”
are scrolled.
“ALARM OFF” is scrolled.
“ON 7 :30” is scrolled.
Languages are scrolled.
“RECEIVING” is scrolled.
Radio wave
Minute
Time Zone
Languages
>2Sec.
Pull
Push
훽
훽
Push
훽
The latest reception was successful.
The latest reception was failed.
Pull
훽
Push
훽
Pull
훽
Pull
훽
Push
훽
훽
훽
훽
훽
훽
훽
훽
훽
Second
Minute
Hour
Year
Month
Date
Summer time ON/OFF
Language Setting
Languages are scrolled.
Push
훽
to complete adjustment. The
hands are moved forward until they
are set to the time of the digital
section.
CAUTION !
Do not pull
훽
while the hands are
being moved forward.
Hour
Minute
Alarm on
Pull
훽
Push back
훽
Push back
훽
Push
and
at the same time.
Push
or
.
Max.12 Min.
Hands stops at their initial position.
Hands stops incorrect position( not "12H00M").
To move hands to correct position, push
and
.
: Fast move
: Push one time then hand moves one step
Hands move back to original time.
CAUTION !
Please don't pull
훽
while hands forwarding.
Hands move back to original time.
CAUTION !
Please don't pull
훽
while hands forwarding.
