5 - 20
emPC-X
(
Hardware Manual
)
•
Maintenance
©
Janz Tec AG
Rev. 1.2
5.2
Battery Replacement
CAUTION : Fire Risk
The installed computer board is equipped with a Lithium battery.
Danger of explosion if battery is incorrectly replaced. Replace only with battery of the
same or equivalent type (3-volt lithium coin cell battery).
•
Do not attempt to recharge the battery.
•
Do not disassemble, crush, puncture, short external contacts, or dispose of in fire
or water.
NOTICE: Battery approval
The battery must be a compatible battery type: CR2032 (3 Volt lithium coin cell battery).
The replacement battery must have a NRTL approval.
Compatible battery type for products with extended temperature specifications: CR2032 (3 Volt lithium
coin cell battery) with temperature range -40 .. +85°C or better (Recommended: Murata CR2032X or
CR2032W).
The battery is used for backing up the system time when the power supply is removed.
1. Turn off the computer properly through the operating system, then turn off any external
devices.
2. Disconnect the power supply from the power inlet and disconnect any external devices.
3. Disassemble the housing and locate the battery on the power supply board
4. Remove the battery from the holder (See figure 11)
5. Insert the new battery (See figure 11)
6. Reassemble the housing
1
2
1. Removal: Insert screwdriver at right side and bend so that the battery
pops outs. Use only gentle force, otherwise the battery holder might
be damaged.
The use a plastic tool is preferred to avoid shorting the battery
2. Insertion: Align new battery to the left side of the holder and gently
press down on the right side of the battery until the battery snaps into
the holder.
figure 11: Removing and replacing coin cell battery
Summary of Contents for emPC-X Series
Page 6: ......
