Janus PBX, User Manual

Page: 7 / 11

To program location message, see step 8 in programming instructions.
Enter # # and hang up.
PURPOSE: To Enable Voice Prompt Message: (DEFAULT)
To enable the voice prompt message to say: “Elevator call at the tone
press one to talk, press two for location”
.
• Enter # 94851 or #9000000 and listen for three beeps.
• Enter # * 1180183 * # and listen for three beeps.
• To program location message, see step 8 in programming instructions.
• Enter # # and hang up.
List of Commands for *Programming Mode
NOTE: The phone enters Programming Mode after completing step 2
of the Programming Instructions.
• #0 First Phone Number *#
• #1 Second Phone Number *#
• #2 Third Phone Number *#
• #3 Fourth Phone Number *#
• #4 Identification Code *#
• #5 Programming New Password *# - Set Programming Access Code
• #7 - Records Location Message
• #8 - Plays back Location Message
• #* 1 XXX Y W Z *# - setup code (Default is: #* 1 180 1 8 3 *#)
• XXX - Call Timer [000,060-990], 000=Disable timer
• Y - Push Button Control [0-2]
[0] Push on = turn on/push again = play message
[1] Push on = turn on/push again = turn off
[2] Push and hold = turn on/release = turn off
[3-8] Push and hold to turn on for Y amount of seconds to make
a call. If pushed for less than Y amount of seconds, turn
off/push again = turn off
• W - Unit ID [1-8]
• Z - Voice Mode [0,3 or 5]
• **43 X *# - Ring Time (for outgoing calls) (18-60 range, 50 is default)
• **44 X *# - AUX1 Behavior (0-2), 0 = disabled, 1 = red led, 2 = green led,
3 = VCC mode
• **45X*# - Redial, 0 = disabled (Default), 1 = Dial the number 1 more time,
2 = Dial the number 2 more times.
• **8 XX *# - Set Language (1 = English: default, 2 = Spanish, X= [1-2]
(must have 2 digits)
NOTE: **8XX*# will play both messages according to the order specified.
(Ex// **812*# = English then Spanish or **821*# = Spanish then English)
NOTE: If second message is not used, enter ʻ0ʼ for that message. For
example, if you want to set to play English only you must program: **810*#.
7