POPULUS A-1-NET and POPULUS A-3-NET – Access controller
4/2015
Black line
www.jantar.si
INSTALLATION
A special holder, provided with the controller, is needed for
attachment to the wall. Two screws are enclosed in the box. After
the holder has been affixed, put the controller onto the holder and
press – after you hear the click, it is fixed. If you want to remove
the controller from the wall, put the screwdriver under the
controller’s casing (as close as possible to the holder’s attachment
points) and turn it gently.
Installation holder for A box.
COMMUNICATION
Ethernet:
Connect the controller to the computer through your LAN via
Ethernet connector. Use at least UTP CAT 5e cable. Adjust network
settings of the controller using the Codeks Device Manager
software so that it will function properly in your network.
Please
consult Codeks Device Manager’s manual.
RS485:
Connect the controller to the computer, with one of the power
supplies, with communication converter, from the Spider family:
Spider W5-USB, Spider W5-NET, Spider W40+NET.
The RS485 communication bus is used between the controllers and
Jantar software. Up to 128 controllers can be lined up into one
communication line. The maximum length of the communication
line is 1000 cable meters. It is recommended that you use an FTP
or S-FTP cable. Only a serial connection of controllers in a single
communication line is allowed.
Star (parallel) connection is not
allowed
.
All shields of S-FTP cables must be wired together and at
one
point
connected to the earth. Individual connections to the earth
are not allowed. Do not connect the shield of the cable to the
ground of the controller.
In the event of problems in communication, a termination
resistor needs to be added. We recommend using 120 Ohm
resistors on each side of the cable. Converters are, on the
RS485 side, protected with slow-blow fuses and transient
voltage suppressors.
ACCESS CONTROLLER
As an access controller, it is intended for controlling entries, exits
and passes of users in the system and controlling sliding doors,
ramp, el. strike, turning alarm on/off… It needs to be set with
CODEKS software.
The default address of the controller is the same as the last
digit of the IP address. E.g. if the IP address of the
controller is 192.168.110.105, then the controller's address
is 105.
Reset to the factory settings (brainwash):
When the controller is reset to the factory settings (brainwash), the
controller address is set to 255.
ORDERING CODES
Populus
[box]-[card]-[software]
Box:
A
Card:
1
- 125kHz reading frequency (cards)
3
- reading frequency 13.56MHz (cards)
Communication:
NET
– Ethernet connection
Code
Specification
POPULUS A-1-NET
Access controller in
A
box,
1
outputs, 1 reader, Frequency
125kHz, Integrated Ethernet, for
CODEKS
POPULUS A-3-NET
Access controller in
A
box,
1
outputs, 1 reader, Frequency
13.56MHz, Integrated Ethernet, for
CODEKS
OTHER
Please read through our warranty and disclaimer statements.
Connection scheme and additional support for the use of this
product can be found on:
CONTACT:
Jantar d.o.o.
Kranjska cesta 24
4202 Naklo
SLOVENIA
mail:
