Janssens Victorian Vi-34, Assembly Instructions Manual

Page: 34 / 40

Spindle Opener
(If Equipped)
Insert a 1 inch long bolt in the lower roof window
profile. Slide it to the center and lock it in place with a
nut as shown below.
Next hold the lower U - shaped mount up to the
crossbar and mark the center of one hole. Use a 1/8th
inch drill bit and drill the first hole. Screw the bracket
on, check for level then mark and drill the second
screw hole.
Now slide the brass part of the opener over the screw
that you locked in place on the crossbar. Use the
supplied nylock nut to secure the opener on the top
mounting bolt.
Finally thread the large side bolts into the U - shaped
mount and the opener is installed.
Note: You can also mount the top
with a screw as shown above.
Note: A screw driver, instead of a drill, is
reccomended for tightening the lower mounting
screws. This will prevent stripping out the aluminum
cross bar.