DRUM SANDER FOR WOODEN FLOORS
ED 98
PG.
7/19
INSTRUCTION MANUAL
SETTING THE MACHINE UP
INSTRUCTIONS FOR ASSEMBLING AFTER TRANSPORTATION
In order to start up the machine, proceed as follows:
1.
Fit the tube in place and tighten the handle
pos. 5 fig. A
2.
Put the bar
pos. 4
in the small roll
pos. 3
and lower the tube
pos. 3 fig. A
3.
Insert plug
pos. 6
into the socket
pos. 7
by
rotating the plug clockwise
4
Lift the roller by means of lever
pos. 1 fig. A
DANGER
:
Using the machine before it is completely assembled may cause injuries to
people and/or damages to things. Do not use a machine which is not
completely assembled. Keep all fastenings closed. Adjust the machine
according to specifications.
INSTRUCTIONS FOR ELECTRICAL CONNECTION
CAUTION:
This machine only works with the voltage and frequency shown on the
machine plate. Before connecting the cable to the power supply grid, make sure
that the voltage and frequency available are correct.
DANGER:
Exposing the machine to water or rain leads to a risk of electrocution. Keep the
machine in a dry building.
DANGER:
Incorrect mains connection of the machine leads to a risk of electrocution. In
order to prevent possible electric shocks, always use a three-wire electric
system connected to an electrical earth. For maximum protection against
electric shocks, use a circuit protected by a differential earth fault interrupter.
DANGER:
Tampering with the earth pin in any way may lead to electrocution. Do not cut,
remove or break the earth pin. Do not try to insert a three-pin plug into a socket
or connector which does not have three holes. If the plug does not fit the
socket, consult an authorized electrician.
DANGER:
Using the machine with a damaged plug or power supply cable may lead to
electrocution. If cables or plugs are worn out or damaged in any way, have
them replaced by an electrician or authorized service staff.
