Page 9
GENERAL OPERATION
HANDLE ADJUSTMENT
AFTER THE PROPER WHEEL ADJUSTMENT IS ACHIEVED, ADJUST HANDLE
No matter what the wheel angle is set at, the handle should be
adjusted to the "belt-line" of the operator or to what the operator is
comfortable with (See Figure A).
-
Low setting works best on soft sub floors, plywood, luan,
particleboard and wafer board.
-
In some cases, a higher setting works best on direct glued
down carpet, vinyl or tile on concrete in some cases.
Make certain handle and bolts are secured tightly.
NOTE:
Adjustment by trial at the beginning of a job will allow optimum
performance.
MACHINE OPERATION
A well maintained machine is a productive machine. If not properly
maintained, it could be unsafe and could break down. A scheduled maintenance program should insure a
long system life and a safe work environment.
MACHINE START PROCEDURE
TO RUN MACHINE:
1. Machine MUST be off before plugging machine into power source.
2. Plug machine into extension cord and/or outlet.
3. Turn switch to on.
USER GENERAL INFORMATION
1. Always wear eye protection
2. Keep flammable and fragile objects away from this tool.
3. Always check nuts and bolt to make sure they are tight.
4. Always use the machine with proper voltage specified in the machines nameplate.
5. Do not operate around water or wet conditions without use of GFI on cord (stock #530 Circuit Guard).
6. Use properly grounded cord and receptacle.
7. Unplug from power before servicing or changing blades.
8. Use 12-3 or heavier wire cord, not exceeding 50 feet in length.
9. Do not force machine.
10. Do not alter machine.
11. Keep wheels free from debris.
12. Make sure blade is sharp.
Figure A
