Jansen GTS-1500E, Owner'S Manual

Page: 10 / 21

10
4. Transport
Before moving the machine, stop the engine!
Maintenance and checks
All technical check-ups and maintenance should be done with the engine shut off and the spark
plug cap removed from the spark plug.
While cleaning the shredder, never spray the bearing with a high pressure washer! It could
cause water to enter the bearings which will cause damage to the machine; (this is not covered
by warranty). The two grease nipples on the rotor require lubricating once a year or every 500
hours.
Before putting the shredder into storage grease or oil the bearings, blades and rotor to protect
against corrosion.
1. Points to be checked
2. Cleaning the machine
For engine maintenance refer to the engine manufacturers engine manual.
Note that the first engine oil change is after 5 hours use.
Attention
！
Adjust the belt at good tightness by moving the Engine after every 10 hours use.