14
MECHANICAL ADJUSTMENT
FEED DOG HEIGHT
TO CHECK:
1.
LOWER THE PRESSER FOOT.
2.
TURN THE HANDWHEEL TOWARD YOU UNTIL THE FEED DOG COMES TO ITS
HIGHEST POSITION. THE DISTANCE BETWEEN THE FEED DOG AND THE UPPER
SURFACE OF THE NEEDLE PLATE SHOULD BE 0.8–0.95 MM.
IF IT IS NOT IN THE RANGE, ADJUST AS FOLLOWS.
ADJUSTMENT PROCEDURE:
1.
SELECT THE STRATIGHT STITCH.
2.
LOOSEN THE SCREW (A) .
3.
TURN THE HANDWHEEL TO BRING THE FEED DOG TO ITS HIGHEST POSITION.
4.
IF THE FEED DOG HEIGHT IS LOWER THAN 0.8 MM: TURN ADJUSTING SCREW (B)
IN THE DIRECTION OF (C).
5.
IF THE FEED DOG HEIGHT IS HIGHER THAN 0.95 MM: TURN THE ADJUSTING
SCREW (B) IN THE DIRECTION OF (D).
6.
TIGHTEN THE SETSCREW (A).
0.8–0.95 MM
UPPER SURFACE OF
THE NEEDLE PLATE
(C)
(D)
(A)
(B)
Summary of Contents for MyStyle 100
Page 1: ...SERVICE MANUAL Mystyle 100...
