Janome MOD-100, Instruction Book

Page: 47 / 60

45
Applique
q
Stitch pattern: 28
w
Thread tension dial: 1 to 4
e
Presser foot: Satin stitch foot F
* The stitch patterns 29, 30, 31, 32 and 33 can also be
used.
Place an applique on the fabric and baste or pin it in place.
Lower the needle at the outer edge of the applique.
Sew while guiding the fabric so the needle falls along the
outer edge of the applique.
q
Applique
w
Outer edge
When turning a sharp corner, stop the machine with the
needle at the outer edge of the applique (refer to page 12).
Raise the foot and pivot the fabric around the needle to
change the sewing direction.
• Adjusting the stitch width
Select pattern 28.
Press the mode key
e
until the cursor
r
appears under
the stitch width value.
Press the “–” sign on the value set key
t
to decrease the
stitch width
u
.
Press the “+” sign on the value set key
t
to increase the
stitch width
i
.
e
Mode key
r
Cursor
t
Value set key
The stitch width will be varied based on the centered
needle drop position
y
.
(A) The stitch pattern 32 has a fixed left needle drop
position. When you change the stitch width, the right
needle drop position will change.
(B) The stitch pattern 28 has a fixed center needle drop
position. The stitch width changes symmetrically.
(C) The stitch patterns 29, 30, 31 and 33 have a fixed right
needle drop position. When you change the stitch width,
the left needle drop position will change.
q
w e
4
q
w
(A) (B)
u
i
y
r
t
e
(C)