15
Feed lifting pin
0.75-0.90 mm
Needle plate
mECHANICAL ADJUSTmENT
FEED DOG HEIGHT
TO CHECk:
1. Lower the presser foot.
2. Turn the handwheel toward you to bring the feed dog to its highest position. The height of the feed dog from the
needle plate should be 0.75-0.90mm.
If it is not in the range, adjust as follows.
ADJUSTmENT PROCEDURE:
1. Open the shuttle cover.
2. Lower the presser foot and turn the handwheel toward you until the feed dog comes to its highest point.
3. Loosen the setscrew (A) .
4. Turn the feed lifting pin to adjust the height of feed dog (0.75-0.90 mm).
5. Tighten the setscrew (A).
6. Turn the handwheel toward you to recheck the height of feed dog.
Summary of Contents for JUNO E1015
