JanomeFlyer.com
6
Connecting the Power Supply
First make sure the power switch is off.
Insert the machine plug into the power inlet.
Insert the power supply plug into the wall outlet and turn
the power switch on.
q
Power switch
w
Machine plug
e
Power inlet
NOTE:
Make sure to use the power cable that came with the
machine.
If you turn off the power switch, wait for 5 seconds before
turning it on again.
WARNING:
When running the machine, always keep your eyes on
the sewing area, and do not touch any moving parts such
as the thread take-up lever, hand wheel or needle.
Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
Operating Instructions:
The symbol “O” on a switch indicates the “off” position of
the switch.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If it does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
If you wish to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine.
r
Foot control cord
t
Pin connector
Insert the machine plug of the power supply cable into the
power inlet.
Insert the power supply plug into the wall outlet, and turn
the power switch on.
CAUTION:
Do not pull the foot control cord beyond the red mark.
NOTE:
The foot control cannot be used in the embroidery mode.
q
w
t
e
r
Operating Instructions:
Foot controller Model 21371 is for use with sewing
machine model MC 12000.
Janome 12000 Sewing Machine Instruction Manual
www.janomeflyer.com
12000 Owners Manual/ User Guide
