Janome 5270QDC, Instruction Book, Page: 24 / 84

22
n
Pull the thread loop to take the thread end out through
the needle eye to the rear.
NOTE:
If the thread is caught in the hook and the thread loop
is not formed, remove the thread from the hook and
pull it to take the thread end out through the needle
eye.
b
Raise the threader slowly so a loop of the thread is
pulled up through the needle eye.
Needle Threader
CAUTION:
Turn off the power switch when using the needle
threader.
NOTE:
• The needle threader can be used with a #11 to #16
needle or a blue tip needle. Thread sizes 50 to 90
are recommended.
Do not use thread size 30 or thicker.
• The needle threader cannot be used for a twin
needle.
z
Press the needle up/down button
q
to raise the
needle to its highest position.
Turn the power switch off.
x
Pull the thread up to the left, over the needle threader
guide while holding the thread near the spool with
your hand.
e
Needle threader guide
r
Slit
c
Pull the thread up and slip it between the thread cutter
and face cover from behind.
Pull the thread toward you to cut.
v
Pull down the needle threader knob as far as it will go.
z
e
r
x
c
v
b
n
NOTE:
Be sure that the thread pass the slit
r
of the needle
threader as shown.
NOTE:
Be sure that there is no thread on the threader knob
t
before pulling down the needle threader knob.
q
t