janitza UMG 806, User Manual And Technical Data

Page: 26 / 92

26
UMG 806 www.janitza.com
5. Mounting
5.1 Installation location
DANGER
Danger of electric shock!
Electric shocks lead to serious injuries, including
death.
· Disconnect your system from the power supply
before mounting and connecting the device!
· Secure it against being switched on!
· Check to be sure it is de-energized!
· Ground and short circuit!
· Cover or block off adjacent live parts!
· The installation must only be carried out by
qualifi ed personnel with electrical training!
Mount the meter in switch cabinets or small distri-
bution boards according to DIN 43880 on a 35 mm
mounting rail (for type, see chapter „16. Technical
data“ on page 86) according to DIN EN 60715.
The mounting orientation is arbitrary.
5.2 Mounting orientation and attachment
Proceed as follows to mount the UMG 806 on
the mounting rail:
1. Push in the bottom bolt of the clamping mech-
anism.
Fig. Bottom of the device with bottom
bolt.
2. Place your measurement device on the mount-
ing rail. Press the device onto the rail until the
bottom bolts engage.
click!
Mounting rail
Fig. Mounting on mounting rail
Fig. Device on mounting rail to DIN EN 60715
ATTENTION
Material damage due to disregard of the instal-
lation instructions!
Disregard of the installation instructions can dam-
age or destroy your device.
· Provide adequate air circulation in your installa-
tion environment and, as needed, cooling when
the temperatures are high.