janitza UMG 512-Pro, User Manual And Technical Data

Page: 65 / 120

www.janitza.com
65
UMG 512-PRO
11.4 System
Here you can access the system settings and, as
far as this is possible, change them.
Fig. System settings
1
2
3
4
5
6
7
8
1 Firmware version
2 Serial number of the device
3 Fixed MAC address of the device
4 IP address that is set
5 Gateway address that is set
6 Date and time
7 Password that is set
8 Reset settings
INFORMATION
The settings for time synchronization, date and
time can be changed via the GridVis® software
(see www.janitza.com).
11.4.1 Password
A password can be used to block access to the
configuration. Changing the configuration directly
on the device is then only possible after entering
the password.
The password consists of a 6-digit number.
Setting range:
1-999999 = with password
0 = without password
The factory setting is no password (0).
To change an already set password, you must
know the current password. Remember a
changed password.
Proceed as follows to set a password:
1.Open the System menu.
2.Navigate to the Password setting using buttons
3 or 4.
3.Open the output by pressing button 6.
4.Use buttons 2 to 5 to enter the desired pass-
word.
5.Confirm your entry by pressing button 6 again.
·If you no longer wish to be prompted for a pass-
word, enter "0" as the password.
INFORMATION
If you no longer know the password, you can
only change it using the GridVis® software (see
www.janitza.com).