JPC 100-PRO
14
4. 3
Securing
Mount the device on a flat, clean and burr-
free surface using the retaining brackets
(Fig. 4). Unevenness can lead to damage
of the display and to the entry of dust and
water.
Fig. 4: Rear view with retaining brackets
1. Insert the device from the front into the
installation cutout and press it carefully
against the switchboard cabinet front as
far as it will go.
2. Swing out the retaining brackets on the
back so that the fastening screws are
above the sheet metal of the cabinet (see
Fig. 5).
3. Tighten the fastening screw of one retain-
ing bracket in one corner until the bracket
presses against the sheet metal of the
cabinet.
4. Repeat step 3 for the retaining bracket
located crosswise opposite.
5. Repeat step 3 for the remaining retaining
brackets.
Fig. 5: Swinging out the retaining brackets
ATTENTION
Material damage due to disregard of the
installation instructions.
Tightening the retaining brackets too tightly
will damage the device.
·
Tighten the retaining brackets evenly.
·
Observe the proper sequence when tight-
ening: First in one corner, then crosswise
opposite, and then the remaining retaining
brackets.
·
Max. torque: 0.2 Nm (1.77 in·lb).