Jandy R0474000, Operation Manual

Page: 5 / 12

Page 5
Section 2. Jandy WaterColors
LED Light Operating
Instructions
2.1 To Operate the Light and Change
Colors
Turn the light ON . The  time the light is turned on,
the color sequence begins with the Alpine White. To
change the color, turn the light OFF and then ON within
three (3) seconds. Continue turning OFF and ON until
the desired light color mode is reached. See Table 1 for
the color mode sequence.
Table 1. Jandy WaterColors Lights Sequence
Sequence Order Color Modes
1 Alpine White
2 Sky Blue
3 Cobalt Blue
4 Caribbean Blue
5 Spring Green
6 Emerald Green
7 Emerald Rose
8 Magenta
9 Violet
10 Slow Color Splash
11 Fast Color Splash
12 America the Beautiful
13 Fat Tuesday
14 Disco Tech
NOTE When the light is turned OFF for more than
seven (7) seconds, it will remain in the color set
that is currently active. When the light is turned
back ON, the light will be on the same color set.
2.2 To Reset to the Beginning of the
Color Sequence
Turn the light OFF, wait four (4) to six (6) seconds, then
turn ON, the light will return to the beginning of the
color cycle (Alpine White).
NOTE If an AquaLink RS control system is being used
the color set can be selected using the indoor
controller.
NOTE To synchronize colors on multiple Jandy
WaterColors Light systems wired to separate
switches, perform the above actions on
all of their switches simultaneously. All
Jandy WaterColors Lights will synchronize
automatically if activated by the same switch.
No other accessories are required.
Section 3. Replacing Light Engine
(PCB)
WARNING
Always disconnect power to the color light at the
circuit breaker before servicing the light. Failure to do
so could result in death or serious injury to installer,
serviceman, pool or spa users or others due to
electrical shock.
1. Turn off the main electrical switch or circuit
breaker, as well as the switch, which operates the
underwater light.
2. Be sure to have the following items:
•• A new lens gasket, P/N R0451101 for the large
light or P/N R0400501 for the small light.
•• A light engine. See Table 2 for speci  cation.
WARNING
Replace light engine with the same type. Failure
to replace the light engine with the same type will
damage the light assembly and may cause an
electrical hazard resulting in death or serious injury
to pool or spa users, installers, or others due to
electrical shock, and may also cause damage to
property. Be sure the power is switched OFF before
removing or installing PCB. Allow PCB to cool before
replacing. .
3. To remove the light assembly, unscrew the special
pilot screw at the top of the face ring, remove light
assembly from niche and gently place assembly
on the deck. It is not necessary to drain down the
pool. See Figure 1.
Model Fixture
Voltage
Light Engine (PCB)
Part Number
Jandy WaterColors
Large Light
12 Volt AC R0474000
Jandy WaterColors
Large Light
120 Volt AC R0474100
Jandy WaterColors
Small Light
12 Volt AC R0473900
Jandy WaterColors
Small Light
120 Volt AC R0473900
Table 2. Light Speci  cations