Jandy Ray-Vac
®
Page 4
SECTION 6.
Speed Adjustment After Cleaning
Energy efficient Ray-Vac pool cleaners plumbed
with a Jandy Energy Filter and valve require adjustment
of speed after each cleaning of the main filter. If your
Ray-Vac operates with a booster pump, this adjustment
will not be necessary. If you are uncertain whether your
Ray-Vac operates with a booster pump, check with your
pool professional.
6A. Speed Adjustment
1.
At the equipment pad, turn off filtration pump.
Follow filter manufacturer's recommended
procedures for cleaning main filter. Before
cleaning main filter, be sure to turn the Jandy 3-
port valve so the line to the Ray-Vac is closed.
2.
Check the Jandy Energy Filter bowl. If clogged,
you must clean the filter. Use the following steps:
a.
Grasp clear bowl.
b.
Remove the clear bowl and filter element. If
the bowl is tight, place a large screwdriver
between two of the tabs at the bottom of the
bowl. Use the shank of the screwdriver as a
lever to loosen the bowl.
c.
Rinse off the filter element and replace into
bowl.
d.
Tighten clear bowl by spinning the bowl into
the housing until resistance is felt. Then
tighten ¼ turn further. Hand tighten only.
Figure 9. Ray-Vac Energy Filter and Jandy Valve
From Pump
To
Main Filter
To Ray-V
ac
Turn handle until
pipe to Energy
Filter is closed
Turn handle until
pipe to Energy
Filter is closed
From Pump
To
Main Filter
To Ray-V
ac
Jandy Energy Filter
Turn Clockwise
to Loosen
If the bowl is to tight,
use screwdriver to
loosen
Figure 10. Removing Energy Filter
Jandy
Energy
Filter
Jandy 3-Port
Valve
