Page 8
Section 3. Installation Instructions Model APURE700 and APURE1400
3.1 Materials
and
Tools
NOTE
Salt not included. See pages 17 - 20.
Installation Materials Furnished
Tools Needed for Installation
(1 ea.)
Electrolytic Cell with 2”-2.5” Universal Unions
(1 ea.)
Port Plug with 16 ft (4.88 m) Sensor and O-Ring
(3 ea.)
Universal Union Nut
(1 ea.)
16 ft (4.88 m) DC Power Cord
(1 ea.)
Power Supply/Control Center
(4 ea.)
Anchors and Screws
(2 ea.)
Wire Nuts
(1 ea.)
Owner’s Manual - Warranty Information
Tape Measure
Phillips & Flathead Screwdrivers
Pliers
Hacksaw
Voltmeter to determine line voltage of AC wiring to power supply
Electric Drill Motor and 1/4 “ masonry drill bit for mounting power supply on
block or stucco wall
An NSF
®
approved All Purpose Cleaner Primer
An NSF
®
approved All Purpose Cement (such as Weld-On 794, 793)
3.2 Plumbing
Confi gurations
WARNING
When using electrical products, basic precautions should always be followed, including the following:
• DANGER: RISK OF ELECTRIC SHOCK WHICH CAN RESULT IN SERIOUS INJURY OR DEATH.
Before attempting installation or service, ensure that all power to the device is disconnected/turned
off at the circuit breaker. Connect only to a circuit protected by a ground-fault circuit-interrupter
(GFCI).
• Grounding is required. The unit should be installed by a qualifi ed service representative and
should be properly grounded. (See Earth Bonding, page 11).
• Install to permit access for servicing.
• Read Cautions and Important Instructions on page 4.
Before attempting any electrical wiring, be
sure to read and follow Safety Instructions. Wiring should only be attempted by a qualifi ed
professional.
Summary of Contents for AquaPure APURE1400
Page 2: ......
