J&R MANUFACTURING 250 FSE, Operation And Service Manual

Page: 10 / 56

a. Units without an electrical heater element. The electrical
requirement is 115 volts, single phase, 13A. Have your electrician
directly wire the unit, making field connections inside the junction box
provided. There should be a “designated circuit” for safe servicing of
these units.
b. Unit equipped with an electric heating element. The electrical
requirement is different. It will require either 208 volt or 230-volt single-
phase service (the heater element has decreased wattage at the lower
voltage). Directly wire the unit, making the field connections inside the
junction box provided.
Supply circuit requires three conductors plus
ground (L1, L2, N, G). A two pole, 30-amp breaker is required. Turn the
circuit breaker off and tag it whenever servicing as this is the only way
to completely de-energize all components of the machine.
2. Move unit into position.
1. Your unit will be shipped fully assembled. It can be handled with a
4000 pound capacity forklift. Uncrate and inspect for concealed
shipping damage. Install the casters (packed inside the unit).
INSTALLATION INSTRUCTIONS
Floor: Unit to be installed on a non-combustible floor
4. Clearances: (in inches) From Any Combustibles:
Above Top From Front From Back From Sides From Chimney
Of Casing Connector
12 48 6 1 18
5. Electrical
3. Vent according to venting instructions on the following pages.
Page 2 of 47