Pairing and Operation of the BT-03 Headsets in Helmet-to-
Helmet Intercom Mode. (up to 4 total)
1. Press and hold intercom/search mode button (C) and multifunction but-
ton (F) together until all headsets in the group turn on.
2. Put BT-03 #1 into intercom linking mode by depressing & holding the
multifunction button (F) for approximately 4 seconds until the LED rap-
idly alternates between red/blue flashing.
3. Now put BT-03 #2 into pairing mode by pressing and holding the inter-
com button (C) for approximately 5 seconds until the multifunction but-
ton LED slowly alternates between red/blue flashing.
4. Headsets are paired together when both red/blue flashing turns to a
slow pulsing blue on each headset.
5. Now momentarily press the intercom/search mode button (C) once on
headset #1 to deactivate intercom mode.
6. Then repeat the process to link BT-03 #2 and #3, and then #3 back to
#1 if you are only linking 3 total headsets together for bike-to-bike inter-
com mode.
7. To link a total of 4 headsets together for intercom, after linking #2 to
#3, press the intercom button (C) to deactivate the pair, then repeat the
above process to link #3 to #4.
8. Then press the intercom button (C) to deactivate #3 and #4, and finally
repeat the above process to pair #4 back to #1.
9. Once this is complete, now all headsets in the group can activate and
deactivate intercom conversations with others in the group by pressing
their own individual intercom buttons.
Pairing and Operation with a Bluetooth Enabled GPS
Command Center.
1. Put the BT-03 control head into pairing mode by pressing and holding
down on the multifunction button (F) for approximately 4 seconds until
you see a rapid red/blue alternating flash.
2. From the menu on the GPS command center, go into the Bluetooth sec-
tion and search for “headset”. When JM_CORP-BT03 is displayed on
your screen and you are asked for a passkey, enter: 0000. Your device
should now pair with the BT-03.
3. If you wish to use headset cell-phone functions simultaneously with
your GPS command center, you will need to link the cell phone direct
to the GPS unit as per the linking/operation instructions included with
your particular unit.
4. If any one of the BT-03 headsets receives an incoming navigation com-
mand from the GPS/or cell-phone call, the helmet-to-helmet intercom
operation will be interrupted. Once the navigation command or cell-
phone call has been terminated from the GPS, the intercom, (if active)
will return.
5. Use the volume-up (B) or volume-down (A) buttons on the headset to
adjust the music volume, navigation command volume and/ or cell/
smart phone volume levels.
6. Additional music, navigation command and cell phone volume adjust-
ments can usually be made inside the GPS command center itself, but
the flexibility of these adjustments depends totally upon the particular
brand/model of the GPS unit you are using.
AUX Input Cable Operation.
1. Connect the 2.5mm plug on the end of the aux input cable and the
other end to your music device and play. If music is not heard, hold
down on the volume-up (b) & volume-down (a) buttons together for
approximately 3 seconds until the music is heard.
2. All music volume adjustments to be made from the aux device are to be
made on the music device itself.
Up to 3 Other J&M Bluetooth Headsets
BT-03
BT-03
BT-03
BT-03
