5. General Operation Instructions
General tips for use with iPod
When connection is made to the iPod the music from the SD card will no longer be heard and the iPod will begin charging. The iPod will
begin to play songs or playlists depending on what has been selected on the iPod. Press the "Tune/Disc" lever on the handlebar up to
play the next song. Press the "Tune/Disc" down to play the previous song. Press and hold the "Tune/Disc" up for three seconds to go
to the next playlist. Press and hold the "Tune/Disc" down for three seconds to go to the previous playlist.
General tips for use with aux input
When the Auxiliary audio cable is plugged into the JMDM-IPBT-GL18 the music from the SD card will no longer be heard. Plug the auxil-
iary cable into the satellite radio/MP3 player. The "Tune/Disc" handlebar lever will have no effect on functions of the satellite
radio/MP3 player.
Note:
If both an iPod and auxiliary audio device are used simultaneously the iPod and auxiliary audio will mix together and be heard at
the same time.
4. Locate the white 14 pin plug located in the black rubber boot next to the cross-member and relay box under the seat.
Diagram B
5. Plug the white 14 pin connector from the JMDM-IPBT-GL18 harness into the corresponding plug on the bike.
NOTE:
The cable must
be routed under the frame cross member to prevent damage to the cable.
6. Plug the 20 pin plug on the harness in to the JMDM-IPBT-GL18.
7. Route the short cable with the red 6 pin male/female connectors from the microphone integration terminal, to the black rubber boot
under the seat next to the relay box. Unplug the red 6 pin plugs from the passenger’s headset lead inside the black rubber boot, and
connect the red 6 pin plugs from the microphone integration terminal in series with the passenger’s headset lead.
8. Route the long cable with the red 6 pin male/female connectors from the microphone connection terminal to a location under the
left front fairing pocket and plug the red 6 pin plugs in series with the driver’s headset lead.
9. Plug the black 4 pin plug from the JMDM-IPBT-GL18 into the black 4 pin plug on the microphone integration terminal.
10. If you wish to use the iPod function, route the included iPod cable to your handlebar mounted iPod, or other desired mounting
location.
11. If you wish to use the aux input function, route the included Auxiliary cable to your handlebar mounted satellite radio/MP3 player or
other desired mounting location.
Note:
Connection of the Auxiliary cable to the JMDM-IPBT-GL18 will override the SD card and music
from the SD card will not be heard until the aux cable is unplugged at the main unit.
12. Test the JMDM-IPBT-GL18 by inserting the supplied SD card. Turn the ignition switch to either the On or ACC position and select CD
on the stereo.
Using the “Tune/Disc” up down toggle control on the handlebar, select between individual tracks with each single toggle, or hold
up/down for 3 seconds to change to another folder/CD #.
Important Note:
When installing this unit on 2009-2010 GL-1800s, if you wish to use the factory installed XM satellite radio feature of
your audio system, in conjunction with the J&M digital music player, you will need to purchase at an additional cost J&M part# JMDM-
ADT-GL18.
