Step6:
Now bring the ROKKER amplifier back out from under the dash and use as a template on
top of the cowl (red/black power plug pointing forward) to locate and mark the extra mounting
hole, that will secure the new amplifier. Drill this one new hole using a 3/16” drill bit.
Step7:
Route the new amplifier wiring harness from under the dash, up thru the large grommet
hole, routing the speaker wires down thru to their left and right-side locations, red power wire
to the accessory power wire connection block (as shown below) black ground wire to the
master ground post on top left side of dash cowl, route the 3.5mm plug to the 3.5mm jack from
the Bluetooth controller and plug-in. (For Blackjack without original Bluetooth controller,
purchase alternate Bluetooth controller from JMCorp).
